11 Inch CNC Automatic Horizontal Band Saw Turbine Main Transmit Structure

11 inch CNC horizontal full automatic metal band saw machine

1. Routine examination before operation
1.1 check whether the hydraulic oil is sufficient and sealed well; otherwise, supplement the hydraulic oil or replace the hydraulic pipeline components such as oil plug. A kind of
1.2 check whether the cutting fluid is sufficient. If it is insufficient or the cutting fluid has deteriorated, it shall be added or replaced completely. 1.3 check the saw blade for cracks, missing teeth and other defects, and replace the saw blade in time. 1.4 check whether the saw blade is correctly hung on the saw wheels on both sides. 1.5 check and adjust the steel wire wheel brush to keep a proper position with the saw blade. 1.6 check whether the tension of saw blade is appropriate.

2. Preparation before work
2.1 adjust the position of the guide arm on the movable side. A kind of
2.2 clamp and loosen the jaw several times, and lift and lower the saw blade several times. 2.3 turn on the power switch on the left side of the machine and enter the operable state. 2.4 press the "up" button of the saw blade to make it rise to the top. 2.5 pull down the "tight / loose" handle of the jaw to release the jaw. 2.6 remove the material from the rear side of the machine and put it on the feeding table. A kind of
2.7 pull up the "tight / loose" handle of the jaw and clamp the jaw so that the material is placed in a proper position. 2.8 confirm whether the material is parallel to the fixed jaw, and correct if not. A kind of
2.9 adjust the position of saw frame travel switch. Lift the saw frame to 5cm above the material and stop. Adjust the travel switch iron stop. When you hear the click, fix the iron stop position. (in this way, the saw frame will automatically rise to this position after each cutting).

3. Sawing
3.1 press the "start" button of the saw blade, the saw wheel water pump starts to work, the saw frame starts to fall and feed, and adjust the feed speed by adjusting the feed knob to 2cm / min (at this time, the saw blade should be tightened, or the belt will fall). 3.2 when the saw frame reaches the lower limit, the cutting is completed and the saw blade running stops. At this time, the machine will automatically stop, stop water, and the saw frame will automatically rise.

4 operation termination
4.1 pull down the "tight / loose" handle of the jaw, loosen the jaw and take out the saw material